分享好友 中模头条首页 中模头条分类 切换频道

行业标准规范英汉对照-通用机械(3)

2017-01-02 16:5813240互联网

148 GB/T 10057-1988 塔式起重机检验规则 Tower cranes--Inspection regulation

149 GB/T 10079-1988 全封闭活塞式制冷压缩机 Hermetic reciprocating refrigerant compressor

150 GB 10080-1988 空调用通风机 安全要求 Safety requirements of fan for air conditioning

151 GB/T 10168-1988 挖掘装载机术语 Backhoe loader--Terminology

152 GB/T 10169-1988 挖掘装载机参数 Backhoe loader--Classification

153 GB/T 10170-1988 挖掘装载机技术条件 Backhoe loader--Specification

154 GB/T 10171-1988 混凝土搅拌站(楼)分类 Concrete batching plant--Classification

155 GB/T 10172-1988 混凝土搅拌站(楼)技术条件 Concrete batching plant--Specification

156 GB/T 10175-1988 装载机额定工作载荷 Rated operating load for loaders

157 GB/T 10178-1988 通风机现场试验 Site testing of fams

158 GB/T 10183-1988 桥式和门式起重机制造及轨道安装公差 Cranes--Overhead travelling cranes and portal bridge cranes--Tolerances of manufacture and tracks laying

159 GB/T 10400-1989 装载机的作用力和倾翻载荷的测量方法 Loaders—Methods of measuring tool forces and tipping loads

160 GB/T 10595-1989 带式输送机 技术条件 General specifications for belt conveyers


« 上一页 2/2 下一页 »
举报
收藏 0
打赏 0
评论 0
机械图纸技术要求汇总
一般技术要求1.零件去除氧化皮。2.零件加工表面上,不应有划痕、擦伤等损伤零件表面的缺陷。3.去除毛刺飞边。热处理要求1.经调质处理,HRC50~55。2.零件进行高频淬火,350~370℃回火,HRC40~45。3.渗碳深度 0.3mm

0评论2017-11-29340